Schedule of Ropes and Lines

Schedule of ropes and lines

The following schedule of Tasar ropes and lines  was supplied by Frank Bethwaite, and lists the ropes and lines as supplied on a new Australian Tasar.

Shrouds 3/32    " 1:19 stainless wire BP to BP 3722mm
  Shrouds should be 3722, bearing point to bearing  point (measured inside the thimbles) plus 19mm for a pressed shackle, plus the length of a vernier shroud  adjuster.    - or   3800 if you choose to use a pin style adjuster.
Diamond Stays 3/32" 1:19 " 3353
Forestay (in Jib) 3/32" 1:19 " 3983
Strop 3/32" 1:19 " 250
  Rule C.2.3(d) governs the length of the strop
Halyard wire 3/32" 7:19 stainless wire BP to Bronze swage 220
Halyard wire 3/32" 7:19 BP to cut 5486
Vang wire 3/32" 7:19 cut length 735
         
Main Sheet 8mm 8 plait length 5500
Jib sheets 8mm 8 plait length 7000
Traveller ropes 8mm Soft " 2 x 2670
         
Swing strap adjusters 5mm 8 plait " 1065
Downhaul 5mm 8 plait " 1800
Jib Furler 5mm 8 plait " 2840
Vang line 5mm 8 plait " 3500
Clew outhaul 5mm 8 plait " 3120
C'Board hold-down 5mm 8 plait " 950
      "  
Halyard fall 4mm laid " 5750
Rudder downhaul 4mm laid " 1150
Pull-backs 4mm pre-stretched 2 x 475
         
Aft W/pole holder 12mm OD Vinyl     450
         
Rudder bush 9mm OD Vinyl     28
         
Swing strap erectors 5mm Shock cord   2000
Traveller keeper 3mm Shock cord   1190
Pull backs 3mm Shock cord 1800  
Note:

BP = bearing point all measurements are in mm